Compuprint 4247-L03 Manuel d'utilisateur Page 109

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 142
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 108
Chapter 5. Printer Maintenance and Troubleshooting
Cleaning the Printer
CAUTION:
<2-22> Carefully follow all cleaning instructions, using only the materials
and solutions recommended.
Periodic cleaning will help keep your printer in top condition so that it will always
provide optimal performance.
Before you clean the printer:
1. Turn off the printer.
2. Unplug the power cord.
3. Wait at least 15 minutes for the printhead to cool before starting this procedure.
Cleaning inside the printer
Every few months, use a soft brush and a vacuum cleaner to remove dust, ribbon
lint, and pieces of paper. Remove the ribbon cartridge to prevent the ribbon from
going into the vacuum cleaner. Vacuum any dust from around the printhead and
in the printer cavity.
Attention: Do not allow any staples, paper clips, or small metal pieces to fall
inside the printer.
Cleaning the outside covers
Clean the outside of the printer with a damp cloth and mild soap. Do not use any
spray-type or chemical cleaners anywhere on your printer. Do not put any liquids
or spray near the air vents. For stubborn ink stains on the cover, use a commercial
mechanic's hand cleaner.
Do not use an abrasive cloth, alcohol, paint thinner, or similar agents because they
may cause discoloration or scratching.
Replacing the Ribbon Cartridge
1. Make sure that the printer is turned off for at least 15 minutes.
CAUTION:
The printhead may get hot during operation. Be careful when removing or
replacing the ribbon.
2. Open the top printer cover.
3. Slide the ribbon guide out of the print head.
97
Vue de la page 108
1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 141 142

Commentaires sur ces manuels

Pas de commentaire