Compuprint 10200 Programmer Manual Manuel d'utilisateur télécharger pdf (Page 81)

Commands

ESC @

Initializes the printer. (EPSON)

ASCII Code ESC @

Hexadecimal Value 1B 40

Decimal Value 27 64

This sequence causes the printer:

• to go back to the current printer setup settings

• to cancel any selected print attributes

• to reset the column counter

• to set the horizontal tabulations every 8 columns

• to clear all vertical tabulations

Only the selection of Draft/Quality printing, DLL and the selected character generator are

maintained.

ESC [ K

Sets initial conditions. (IBM 2391 + only)

ASCII Code ESC [ K

init id

Hexadecimal Value 1B 5B 4B

init id

Decimal Value 27 91 75

init id

This command causes the printer to reset to its initial status:

The n

and n

parameters specify the number of bytes in the escape sequence normally,

= 2 and n

= always 0.

init

The init parameter specifies to which condition the printer should initialize, normally

init = 0,1,4,5,254,255.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 233 234

Pas de commentaire

Compuprint 10200 Programmer Manual Manuel d'utilisateur Page 81