Compuprint 6314 CDL Manuel d'utilisateur télécharger pdf (Page 11)

CDL – Programmer Manual

STX Onnnn – Vertical offset

To move the whole label lengthwise with respect to the direction of the printing, you can enter a

vertical offset. The four digit number

nnnn

gives the offset in hundredths of an inch

“according” to

the emulation used (for this, see the user’s manual for the printer used).

e.g.

STX O0225

(if you use the

REFERENCE

OFFSET

210

) gives an offset of 15 hundredths of an

inch, that is the printer, before starting to print, will advance the paper by 15 hundredths of an inch

and the printing will appear 15 hundredths of an inch “higher up” than “normal”.

If the offset is positive, it will take effect from the first label, if it is negative, from the second

onwards.

STX o – Immediate cut

When the automatic cutter is fitted and enabled, this command activates an immediate cut.

STX P – Dump mode

After this command, the printer goes into

dump

mode. This means that the command interpreter is

disabled and all characters received by the printer are printer as hexadecimals: to exit this mode the

printer must be switched off and on again. The command is equivalent to pressing both the ON-

LINE and FEED buttons when it is switched on (for further information, see the user’s manual for

the printer used) except that it does not print a test label.

STX p - Off-line after a batch of labels

This command causes the printer to go

off-line

, unlike with the

STX J

command, see relevant

paragraph, after each batch of labels it prints.

STX Q – Cancel all

This is equivalent to the commands

STX qA

STX qB

STX qD

STX qE

: it cancels all the drives

including RAM and flash memories.

STX q(A/B/C/D/E) - Cancel drive

This command “cleans” drives A, B, C, D, E

respectively. The result is that all the images or

labels previously saved are cancelled. Cancelling the non-volatile flash memory may take several

seconds.

e.g.

STX qB

cancels the non-volatile flash memory of the base machine.

STX r – Paper sensor in reflection mode

After receiving this command, the sensor will operate in reflection mode (for the use of sensor

operating modes, see the user’s manual for the printer used).

After an

STX m

command (see relevant paragraph),

nnnn

is read as tenths of a millimetre.

Volatile memory drive A (RAM), and flash memory drives D and E (non-volatile) are only available when present (in

an expander card) (for further information, see the user’s manual for the printer used).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Compuprint 6314 CDL Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimeurs Compuprint 6314 CDL