Compuprint 6314 CDL Manuel d'utilisateur télécharger pdf (Page 19)

CDL – Programmer Manual

+pii – Increase the previous field

It increases the immediately preceding field by

with the exclusion of the letters. The empty spaces

are filled with the character

e.g.

+01

increases the previous field by

and “fills” digits that are not significant with

-pii – Decreases the previous field

It decreases the immediately preceding field by

with the exclusion of the letters. The empty spaces

are filled with the character

e.g.

-01

decreases the previous field by

and “fills” digits that are not significant with

>pii – Increase the previous field

It increases the immediately preceding field by

including the letters. The empty spaces are filled

with the character

e.g.

> 1

increases the previous field by

and “fills” the digits that are not significant with a space

character.

<pii – Decreases the previous field

It decreases the immediately preceding field by

including the letters. The empty spaces are filled

with the character

e.g.

> 1

decreases the previous field by

and “fills” the digits that are not significant with a space

character.

2.1.2.1.2 Special commands

Despite the fact that they are preceded by the character

STX

, these commands (in effect there is only

one) are label definition commands and not system commands.

STX Sn – Retrieve the register

With command

, see relevant paragraph, the fields are progressively saved (from

) in the

registers. To retrieve them you must use this command in which

is the register to be retrieved.

Since the registers are in any case filled, whether or not you use command

, when they are

retrieved you must bear in mind that the first field of the label is saved (regardless of the fact that it

is followed by

, or not) in register

the second in

and so on.

e.g.

STX SC

retrieves the setting saved in register C, that is the third field of the label.

2.1.2.1.3 Object definition commands

These commands are used to “build” the actual label. You can define the properties and the position

of geometric figures, alphanumerical fields (strings), bar codes and graphic images.

Generally, the syntax of the commands is as follows:

a b cd eee ffff gggg nn...n

is the rotation of the object. It may be

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Compuprint 6314 CDL Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimeurs Compuprint 6314 CDL