CDL – Programmer Manual
18
a Speed (ips
33
)
A 2
B 2
C 2
D 2,5
E 3
F 3,5
G
34
4
H 4,5
I 5
J 5,5
K
35
6
L 6,5
M 7
N 7,5
O
36
8
e.g. with command
SG
the paper advances at a speed of 4 ips.
s(A/B/C/D/E)nn...n – Save the current label
You can save the current label in the RAM
37
(
A
) or in the flash memory (
B, D,
or
E
) with the name
nn...n
and later retrieve it using the command
rnn...n
Tnn – Set the line terminator
For label definition commands and some system commands it is essential to end the line with the
character
CR
: otherwise the command interpreter cannot distinguish between the end of the previous
command and the beginning of the next one. Some computers do not allow you to send the line end
character
CR
and it must be replaced by another using this command. The two digit number
nn
is
the hexadecimal code of the replacement line terminator.
e.g. after the command
T00
, the character
NULL
(
00
10
,
00
H
) becomes the line terminator and all the
lines must “end” with this character.
X – Label definition mode terminator
On receiving this command, the printer exits the label definition mode and can once again receive
immediate and system commands. Unlike command
E
, with this command the label that is stored in
the memory is not printed until the command
STX G
is received, see relevant paragraph.
33
Inches per second.
34
Default and max. speed.
35
Default speed for models with expander card.
36
Max. speed for models with expander card.
37
Volatile memory drive A (RAM) is available only when installed (in an expander card) (on this subject, see the user’s
manual for the printer used).
Commentaires sur ces manuels