Compuprint 6314 CDL Manuel d'utilisateur télécharger pdf (Page 13)

CDL – Programmer Manual

n Present sensor Cutter

0 Disabled Disabled

1 Disabled Enabled

4 Enabled Disabled

5 Enabled Enabled

e.g. STX V4 enables the present sensor and disables the cutter.

STX v - RS 232 port configuration

It prints the configuration of the RS 232 port as it appears on the test label.

STX Xa – Current drive

With this command you can select the current drive C (see i commands STX Iafnn...n and

s(A/B/C/D/E)nn...n) as the volatile RAM memory (a=A) or as the non-volatile flash memory (a=B,

D o E)

e.g. STX XA selects drive C as the volatile RAM memory.

STX Z – Print test and configuration

It prints the configuration and the test label in the same way as when you press the ON-LINE and

FEED buttons when the printer is switched on (for further information, see the user’s manual for the

printer used) without, however, going into dump mode..

2.1.2.1 Label definition commands (STX L)

They are included between the STX L and the E (or X or s(A/B/C/D/E)nn...n) commands. They are

not generally preceded by any particular character (neither STX or SOH) and “end” with the CR

character.

2.1.2.1.1 Local setting commands

These commands permit you to set a number of local label parameters like temperature, print speed

and label quantity.

:nnnn – Cut command

Like the cnn command below (see), nnnn is the number of labels printed before the cutter operates

(if it is fitted and enabled). Unlike the cnn command which can contain only two digits, this

command accepts up to four digits.

The default current drive is B. The A when the RAM is installed (in an expander card). Drives A, D and E are

available only on expander cards.

The line terminator can be replaced, in label definition mode, by another character with the command T (see sect.

2.1.2.1.1 on page 13) which is a local command and therefore is valid only for the current label.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 52 53

Pas de commentaire

Compuprint 6314 CDL Manuel d'utilisateur Page 13